CGM seat slurry I. Features CGM seat is a kind of cement slurry for cementing material, with high-strength composite admixture and aggregate, you can use the site after mixing with water, with no shrinkage, high strength, easy construction and other characteristics special seat slurry seat pad for a variety of devices pulp. Second, the scope is mainly used in the slurry 1.CGM seat seat installation works and concrete slurry Dun cushion construction. Technical performance 2.CGM seat pulp strength and expansion rate and other technical indicators are as follows: compressive strength (MPa) expansion rate (%) 1 day ≥30 ≥0.02 3 天 天 ≥65 ≥50 28 Third, use 1 for basic surface roughening, convex surface height should be controlled more than 2cm. The surface should handle clean and should not have oil, dust and loose concrete, Block 1 hour before watering wet pulp should base surface, pulp should initially cleared seat surface water. According to plate size and seat height pulp production trapezoid motif. 2. When the slurry mixing artificial or mechanical agitation according to the scope of the factory to provide water, must be uniform. 3. When the stirred slurry can be molded into a slug when you can use, the stirred slurry injection seat to place the mold body, should be pouring layered tamping each layer thickness should be controlled at about 50mm, slurry surface shape should be low in the middle surrounded by high arc, while beneficial to exclude air pad placement. 4. When the seat back surface of the slurry water stains disappear (depending on the construction environment temperature) to place the plate and measured elevation, seat pads placed on hand to suppress the slurry application, with a wooden hammer percussion pad surface, it steady decline, when not knock oblique strike. After the elevation of the pad down to stop knocking regulations, review elevation plate again. 5. straw bags and other items covered by water conservation, not shock and vibration during maintenance.